WARNING:
Do not expose speakers to direct sunlight for
extended periods.
Do not use speakers in extremely hot, dusty,
humid or damp conditions.
SPK-S20
Do not attempt to disassemble these speakers.
There are no user serviceable parts inside.
User Manual
Opening these speakers may void your warranty.
For technical support please visit
SPECIFICATION
Total Output Power: RMS 1W
> RMS 0.5W Per Channel
> 2” Full Range Speaker Driver
> Frequency Response: 150Hz~18KHz
> Magnetically Shielded
Please read carefully before use
> Power Indicator
> Dimension: 60(W) x 85(D) x 133(H)mm
SYSTEM CONNECTION
OPERATING METHOD
OPERATING METHOD
CONNECTING METHOD
USB connecting cable
LED
1: Plug the USB cable in a spare USB socket on your computer.
NOTE:
2: In the first instance the operating system should detect the
speaker and automatically load the correct drivers.
The power LED will light when connected to an active USB port.
The LED will flicker when the speakers are recieving an audio signal.
3: Adjust the volume to the desired level.
TROUBLE SHOOTING:
NOTE:
Device not recognised:
Confirm that the operating system has native drivers for USB Audio
devices.
In some cases Win98SE or ME can
not detect USB audio devices
and switch to them.
If the operating system does not
detect the USB speakers,
Audio will stop at full volume:
Ensure that the USB port used to connect the speakers is not
overloaded. Move connection to other ports or connect using a
powered USB hub.
please open the “Control Panel”,
select “Sound and Audio Devices”.
Choose the “Audio” page and then
change the “Default Device” to
“USB Device” or “C-Media USB
Device”
|
NEC Electronics America Cell Phone NDA 24305 User Manual
Mantis C2000 User Manual
Life is good VX11000enVTouch User Manual
LG Electronics MFL6699040210 User Manual
IBM x Series 200 User Manual
HHB comm PERSONAL COMPACT DISC RECORDER CDR 830 User Manual
Hamilton Beach 44241 MX User Manual
Ericsson UM10067 User Manual
Ericsson TEMS EDGE User Manual
Audiovox MP5610 User Manual